Blog

Waterfall Card

design by Vy Tran

These directions have been adapted to use panels of your choice

Supplies Needed:

Colored cardstock

• 4 ¼” x 11”, scored at 5 ½” along the long side
• 2 ¼” x 10 ¼”, scored at 3 ¼”, 3 ¾”, 4 ¼”, and 4 ¾” along the long side
• 4” x 1”

Basic White cardstock

• 3 ½” x 4 ¾”
• 2″ x 5 ¼”

Portrait stamped images

• FOUR 2 ½” x 3 ¼” panels

Coordinating DSP

• 4 ¼” x 5 ½”
• 2 ½” x 3 ¼”
• 3 ½” x ½”

Directions:

1. On smaller white cardstock mark ⅝” and 3 ⅝”, stamp sentiment between those markings, a small image below lower marking, then erase marks.
2. Reinforce scored lines on small cardstock
3. Put your images in order & beginning with the last image, glue it to the shorter side of the cardstock
4. Put glue on to the scored section above that (2 ¼” x ½”) & adhere the 2^nd to last image, then the next, then the cover image
5. Glue 4” x 1” piece of cardstock to the back/bottom/centered of the assembly
6. Open assembly & adhere the stamped white cardstock piece from #1, centered & at the bottom of the longer side, leaving an even border
7. Adhere DSP to front of card base
8. put glue on the back of the wings that stick out (*ONLY glue the part that sticks out) from the assembly & adhere to card front in portrait position
9. Add an embellishment to each side of the wings so it looks ‘tacked’ down
10. Add the 3 ½” x ½” strip of DSP to the bottom of the 3 ½” x 4 ¾” piece of white cardstock, about ½” from the bottom, then adhere to the inside of your card
11. Take a scrap of cardstock about ½” x ½” and adhere a dimensional, peel of backing and adhere just under the pull tab, this makes it easier to grab the tab